6309DDUC3

HPS – High Performance Standard 6300 Series Single Row Deep Groove Ball Bearing

Item #100761295

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

Locking Device	No Locking Device
Lubricant	Mul-Temp SRL
icNumber	7695966
I.D.	45 mm
Inch/Metric	Metric Bore
Inner Ring Width	25 mm
Limiting Speed - Oil	8000 rpm
Rows of Balls	Single
Ball Material	Steel
Static Load Rating [Max]	7,210.00 lbf
Outer Ring Width	25 mm
Material	Steel
Seal Material	Buna-N
Enclosure	Double Sealed
Corner Radius [Min]	1.50 mm
Contact Angle	0°
Dynamic Load Rating	12,511.00 lbf
Limiting Speed - Grease	4800 rpm
Bore Type	Round Bore
Width	25 mm
Radial Internal Clearance Specification	Greater Than Normal Clearance
Cage Material	Pressed Steel
O.D. Type	Straight
Precision	Standard
Snap Ring	No Snap Ring
Seal Type	Contact Seals
No. in Set	Single Bearing
Bearing Type	Radial
Capacity	Standard Capacity
O.D.	100.0000 mm
Preload Level	None
Cage Type	Metal
Radial Internal Clearance	C3
Precision Level	Standard (ABEC 1)
Weight	1.841 LB
EAN or UPC	29176065750